Set your delivery region
Deliver to
Fiji
Update delivery region
30 Days
Returns
View Favourites

All Categories

    Home TV & AV AV Splitters / Switches

    Raspberry Pi Display 1.3inch OLED Module for Raspberry Pi Pico, 64x128, SPI/I2C

    FJ $41.99 excl. VAT

    Raspberry Pi Display 1.3inch OLED Module for Raspberry Pi Pico, 64x128, SPI/I2C

    the selected product is not available.

    Displays

    Description

    NOTE: Raspberry Pi Pico is NOT included. The pictures are for reference ONLY.
    1.3inch OLED Display Module For Raspberry Pi Pico, 64x128 Pixels, SPI/I2C Interface
    Features:
    - Adopts both 4-wire SPI and I2C interface, better compatibility, fast data rate - 2 x user buttons for easy interacting - Standard Raspberry Pi Pico header, supports Raspberry Pi Pico series boards

    OLED and its controller:
    - This OLED integrates the SH1107 controller which has 128x128 bits SRAM, supports 128x128 resolution. The controller features SPI/IIC/ 6800/8080 interface and 256 brightness levels. The resolution of this 1.3inch OLED is only 64x128, only half of the SRAM is used. - This OLED uses four-line SPI and I2C interface for communicating, which supports higher compatibility and speed.
    Protocol:

    Note: The MISO pin is hidden, for more details, you can refer to Datasheet Page11.
    - CS: Chip selection of the slaver, the chip is activated when CS is Low; - SI(D1): This is MOSI pin, the pin is used to transmit data from master to slaver; - SCL(D0)is the SPI clock - A0: This is the DC pin, it is used to determine the data input, DC=0: command is sent; - SPI communication has data transfer timing, which is combined by CPHA and CPOL. - CPOL determines the level of the serial synchronous clock at an idle state. When CPOL = 0, the level is Low. However, CPOL has little effect on the transmission. - CPHA determines whether data is collected at the first clock edge or at the second clock edge of the serial synchronous clock; when CPHL = 0, data is collected at the first clock edge. - According to the figure, SCL is high in idle and it starts to transmit data at the second edge. therefore the timing is Mode 3 (0x11). Data is transmitted in MSB format.
    User Guides, Resoures, please check HERE




    Operating voltage
    3.3V
    Communication Interface
    4-wire SPI, I2C
    Display Panel
    OLED
    Driver
    SH1107
    Resolution
    64×128 pixels
    Display size
    14.70 × 29.42mm
    Pixel size
    0.15 × 0.15mm
    Dimensions
    52.00 × 25.00mm


    Manufacturer Part No:

    19376
    Brand:

    Raspberry Pi

    Product Type:

    Module
    UPC

    -
    Product Family:

    Display
    Shipping Weight:

    1 kg
    PB Part No:

    SEVRBP0341
    Product Model:

    1.3inch OLED



    Warranty:
    12 months *
    * Warranty period is as stated above unless the manufacturer has chosen to specify a longer period.
    All warranties are return to base unless otherwise specified.

    Questions?

    In order to assist us in reducing spam, please type the characters you see:

    You may also like